frame check sequence वाक्य
उदाहरण वाक्य
मोबाइल
- The full-duplex side usually will register frame check sequence errors, or runt frames.
- The Frame Check Sequence ( FCS ) is the last four bytes in the standard 802.11 frame.
- The frame check sequence ( FCS ) field is used for determining whether an individual frame has an error.
- This is used to tell if the packet had an frame check sequence ( FCS ) error in reception.
- A single bit error in either the packet or the Frame Check Sequence causes the ground station to reject the packet.
- Still, the full duplex device, not expecting incoming frames to be truncated by collision detection, will report frame check sequence errors.
- The start and end of the frame are signalled by the'flag', and error detection is carried out by the frame check sequence.
- A frame check sequence ( FCS ) is appended to each fragment, which is then transmitted by the next available active PME in the aggregated group.
- When used as EtherType, the length of the frame is determined by the location of the interpacket gap and valid frame check sequence ( FCS ).
- A frame check sequence is responsible for error checking, which, due to the system's simplicity, must be done on the application layer.
- Error control protocols such as LAPM use frames of variable lengths, each beginning with a header and ending with a frame check sequence trailer ( a cyclic redundancy check ).
- The frame ends with a frame check sequence ( FCS ), which is a 32-bit cyclic redundancy check used to detect any in-transit corruption of data.
- The frame check sequence ( FCS ) is a 16-bit CRC-CCITT or a 32-bit CRC-32 computed over the Address, Control, and Information fields.
- A CCMP Message Integrity Code ( MIC ) which protects the integrity and authenticity of the packet and the frame check sequence ( FCS ) which is used for error detection and correction.
- When cut-through switching is used in Ethernet, because the frame check sequence appears at the end of the frame, the switch is not able to verify the integrity of an incoming packet before forwarding it.
- A Frame check sequence, which is a type of Checksum and is usually 16 bits ( 2 bytes ) is appended to each packet so the ground station can calculate whether the packet has been received error-free.
- If the frame has a maximum sized address of 32 bits, a maximum sized control part of 16 bits and a maximum sized frame check sequence of 16 bits, the overhead per frame could be as high as 64 bits.
frame check sequence sentences in Hindi. What are the example sentences for frame check sequence? frame check sequence English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.